With EU wall plug. 9-step 10Amp battery charger for 12V Lead Acid; AGM; GEL starter & Deep Cycle batteries from 3 – 400Ah that demand accurate temperature controlled charging and unsupervised safe long term maintenance. Voltage selection (14.4V / 14.7V) ensure the battery receives charge at the correct voltage. Ampmatic charge control adjusts current to suit any battery size or condition for fastest and most complete charge i.e. small batteries receive less current; large batteries up to maximum current. - ''Power Supply'' mode delivers stable power for vehicle system reprogramming; show room vehicle demo or retaining memorised settings when battery cables are disconnected to fit powered accessories or replace the battery - Charging Amps: 10A (AmpMatic) - Ampmatic: Microprocessor adjusts charge current to match battery size / condition for perfect LiFePO4 charge curve; for fastest and most complete charge - Selectable charge: 14.4V for standard lead acid batteries / 14.7V for premium AGM or Deep Cycle - Save: Low Volt Start of 0.5V + 2-step desulphation recovery - For Lead Acid; AGM; GEL & Deep Cycle 12V batteries from 3 – 400Ah - Powersupply 13.6V - Indoor / Outdoor (lowest temperature: -40°F / -40°C) - Input: Global (100-240V 50-60Hz); high efficiency (CEC listed); fully sealed - Weatherproof case with wall mounts - Incl. 6ft / 180cm AC supply lead and 6ft / 180cm charge lead ending in SAE connector. Weatherproof battery lead & standard battery clip set